Psiber Data Systems RF3D Instrukcja Użytkownika Pobierz pdf (Strona 27)

manual

The next array, with the attribute id=”ref-9”, contains gain values in dBi for the values

of theta listed above, representing 72 data points at 2.4 GHz.

<SOAP-ENC:Array id=“ref-9“ SOAP-ENC:arrayType=“xsd:ﬂoat[72]“>

</SOAP-ENC:Array>

The next array, with the attribute id=”ref-10”, contains a phi value (angle measure in

degrees) for one data point at 5 GHz. This array is rudimentary, since the antenna is

not used for the 5 GHz band.

<SOAP-ENC:Array id=“ref-10“ SOAP-ENC:arrayType=“xsd:ﬂoat[1]“>

</SOAP-ENC:Array>

The next array, with the attribute id=”ref-11”, contains a theta value (angle measure

in degrees) for one data point at 5 GHz.

<SOAP-ENC:Array id=“ref-11“ SOAP-ENC:arrayType=“xsd:ﬂoat[1]“>

</SOAP-ENC:Array>

The next array, with the attribute id=”ref-12”, contains a gain value in dBi for the value

of phi listed above, representing one data point at 5 GHz.

<SOAP-ENC:Array id=“ref-12“ SOAP-ENC:arrayType=“xsd:ﬂoat[1]“>

</SOAP-ENC:Array>

The next array, with the attribute id=”ref-13”, contains a gain value in dBi for the value

of theta listed above, representing one data point at 5 GHz.

<SOAP-ENC:Array id=“ref-13“ SOAP-ENC:arrayType=“xsd:ﬂoat[1]“>

</SOAP-ENC:Array>

All other lines in the ﬁle must remain unchanged.

1 2 ... 22 23 24 25 26 27 28 29 30 31 32 ... 46 47

Brak uwag

Psiber Data Systems RF3D Instrukcja Użytkownika Strona 27